Minka Lavery 1625-613 Installationsanleitung PDF herunterladen

ASSEMBLY THE FIXTURE (FIG. 1)

1. Shut off the power supply at the fuse box or circuit breaker.

Remove the old fixture from ceiling, including the old cross

bar.

2. Carefully unpack your new fixture and lay out all the parts in a

clear area. Take care not to lose any small parts necessary for

installation.

3. Adjust the arms to its desired position.

4. Thread the nipple (L) into the coupling (O) and secure with

hex nut (N).

5. Put the tube (M), check ring (K), wheel (J) & (I) over the nipple

(L) in order,

6. Assemble the extension rod (G) together using the nipple (H),

then thread the bottom end of the extention rod (G) onto the

nipple(L) tightly.

7. Put the ring (E) over the top end of the extension rod (G) and

secure with loop (F).

(Remark: there is one piece 11” L. chain included in the

hardware bag. You could add the chain on to increase the

fixture height if needed)

8. Put the glass shade(T), spacer ring (S) over the socket (U),

then secure with socket ring (R) using socket ring tool(Q).

9. Install the bulbs in accordance with the fixture’s specifications.

DO NOT EXCEED THE MAXIMUM WATTAGE RATING!

MOUNTING THE FIXTURE

10. Attach the mounting plate (B) to the outlet box using the outlet

box screws (A). The side of the mounting bar marked “GND”

must face out.

11. Follow the wiring instructions carefully (See Fig.2).

12. Attach the fixture main body onto the mounting plate (B) by

attaching the ceiling canopy(D) onto the mounting plate (B)

using the mounting screw (C).

Wiring (See fig.2)

1. Connect the electrical wires as follows. Connect the black

wire from the fixture to the black (HOT) house wire. Connect

the white wire from the fixture to the white (Neutral) house

wire. Make sure all the wire nuts were secured. You may wrap

the connections with electrical tape. If your outlet box has a

ground wire (Green or Bare Copper) connect fixture’s ground

wire to it. Other wise attach the bare copper fixture wire to the

green ground screw on the mounting bar.

2. Tuck the wire connections neatly into the ceiling junction box.

‘

Your installation is now complete. Turn on the power supply of

the junction box to test the fixture.

Fig.1

INSTALLATION INSTRUCTION FOR FIXTURE#1625-613, 1629-613

READ AND SAVE THESE INSTRUCTIONS

ARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

Notice: It is important to use proper chain pliers (not

included) to OPEN and CLOSE the chain included

with this fixture. Do not open them with other tools

that may twist or stress the chain links. It is important

to use proper chain pliers like the ones shown in the

diagram.

Inhaltsverzeichnis

Seite 1

8 ASSEMBLY THE FIXTURE (FIG. 1) 1. Shut off the power supply at the fuse box or circuit breaker. Remove the old fixture from ceiling, including the

Kommentare zu diesen Handbüchern

Keine Kommentare

Minka Lavery 1625-613 Installationsanleitung

Stöbern Sie online oder laden Sie Installationsanleitung nach Nein Minka Lavery 1625-613 herunter. Minka Lavery 1625-613 Installation Guide Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Minka Lavery 1625-613