Minka Lavery 2931-84-L Bedienerhandbuch PDF herunterladen

INSTALLATION INSTRUCTIONS FOR 2931-L

For LED wall mount fixture

WAR N I NG ! S H UT P OW E R O F F AT F US E OR C I RC UI T BR E AK ER .

AV E R T I S S E M E N T ! C O U P E R L E C O U R A N T A U N I V E A U D E S F U S I B L E S O U D O D I S J O N C T E U R .

Fig.1F

Fig. 2

Fig.3

IMPORTANT: Fixture should be installed by a

qualified electrician to ensure proper wiring and

installation.

Dimmable with C-L (CFL & LED) type and

Incandescent/Halogen type dimmers

MOUNTING THE FIXTURE (Fig. 1)

1. Shut off power at the fuse box or circuit breaker box. If

necessary, remove the existing fixture and its mounting

hardware from the wall.

2. Carefully remove the new fixture from the carton and check

that all parts are included as shown in the illustration.

3. Attach the mounting plate (A) to the outlet box using outlet

box screws (B) (Size: 8-32*1/2’’L). The side of the

mounting plate marked “GND” must face out.

CONNECTION THE WIRES (Fig. 2)

4. At this point, connect the electrical wires as shown in Fig.2,

making sure that all wire connectors are secured. If your

outlet box has a ground wire (green or bare copper),

connect the fixture's ground wire to it. Otherwise, connect

the fixture's ground wire directly to the mounting plate

using the green screw provided. After the wires are

connected, tuck them carefully into the outlet box.

FINISHING THE INSTALLATION (Fig. 1)

5. Align Fixture (E) over mounting plate (A) and secure with

screws (D).

Your installation is now complete. Return power to the outlet box

and test the fixture.

CAUTION /ATTENTION: When handling the fixture, do not

apply pressure to the LEDs. Hold the fixture by the base or

fixture body (E) only.

Replacing LED module (Fig.3)

The LED module can be replaced by a qualified electrician

without cutting the wires and without damaging the decorative

element to which the fixture is attached. See installation steps for

more details (Fig 3.)

Warning: Turn off power at the fuse box or circuit

breaker before replacing LED module.

a. To remove the fixture from the wall: loosen screws (D), and

remove the wire connectors. Then place the fixture on a

clear flat surface.

b. Loosen screws (P), hex nuts (F) screws (M), wire fastener

(N) and carefully remove the LED module (T).

c. Reverse steps a-b for installing the new LED module.

Note: The LED module should be provided by a specified

supplier.

For LED wall mount fixture 1

Inhaltsverzeichnis

Seite 1 - For LED wall mount fixture

INSTALLATION INSTRUCTIONS FOR 2931-LFor LED wall mount fixtureWAR N I NG ! S H UT P OW E R O F F AT F US E OR C I RC UI T BR E AK ER .AV E R

Kommentare zu diesen Handbüchern

Keine Kommentare

Minka Lavery 2931-84-L Bedienerhandbuch

Stöbern Sie online oder laden Sie Bedienerhandbuch nach Nein Minka Lavery 2931-84-L herunter. Minka Lavery 2931-84-L Instructions / Assembly Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Minka Lavery 2931-84-L