Minka Lavery 977-1-138 Installationsanleitung PDF herunterladen

INSTALLATION INSTRUCTIONS

For Models 977-1-138

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

Fig.1

Fig. 2

MOUNTING THE FIXTURE

1. Shut off power at the fuse box or circuit breaker box.

Remove the old fixture from ceiling, including the crossbar.

2. Carefully unpack your new fixture and lay out all the parts

on a clear area. Take care not to loose any small parts

necessary for installation.

3. Attach the crossbar (B) to the outlet box using the two

screws (C) from the outlet box. The side of the crossbar

marked ”GND” and with two mounting screws must face

out.

4. Thread the two Mounting Screws (A) on crossbar about

1/4", align with the pre-drilled holes in the canopy (D).

5. Feed wire thru rods (F) as required getting desired height.

While holding the center tube (F) turn counter-clockwise

four full turns. Attach each additional center tube (F) by

turning it clockwise until assembled.

6. While holding the canopy (D) toward the ceiling, connect the

electrical wires as follows (See Figure 2).Connect the black

wire from the fixture to the black house (hot) wire. Connect

the white wire from the fixture wire to the white (neutral)

house wire. Make sure all wire nuts are secured. You may

wrap the connections with electrical tape. If your outlet has

a ground wire (green or bare copper), connect fixture’s

ground wire to it. Otherwise connect fixture’s ground wire

directly to the crossbar using the green screw provided.

Tuck the wire connections neatly into the ceiling junction

box as you hold the canopy (D) assembly toward the

ceiling.

7. Place the metal frame (H) and glass shade (J) over the

socket (G).Then secure the glass with retaining ring (I).

8. Attach the canopy (D) onto outlet box and secure it with

nuts (E).

9. Install the light bulbs in accordance with fixtures

specifications. DO NOT EXCEED THE MAXIMUM

WATTAGE RATING!

FIXTURE

WIRES

Black or

Smooth

USE

WIRES

Black

(Hot)

FIXTURE

WIRES

White or

Ribbed

USE

WIRES

White

(Neutral)

FIXTURE

WIRES

Bare

Copper

(Ground)

USE

WIRES

Green or

Bare

Copper(Gr

ound)

INSTALLATION INSTRUCTIONS 1

Inhaltsverzeichnis

Seite 1 - INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS For Models 977-1-138 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. Fig.1 Fig. 2 MOUNTING THE FIXTURE 1. Shut

Kommentare zu diesen Handbüchern

Keine Kommentare

Minka Lavery 977-1-138 Installationsanleitung

Stöbern Sie online oder laden Sie Installationsanleitung nach Nein Minka Lavery 977-1-138 herunter. Minka Lavery 977-1-138 Installation Guide Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Minka Lavery 977-1-138